Snom 220 User Manual download pdf (Page 22)

Basic Functions

Handset / Handsfree / Headset

The snom220 supports calls being made while using the handset or the

handsfree capability. During a call it is possible to switch between both

modes by pressing the function keys

/ or the Speaker key

on the right side beside the display.

If a headset is connected and the audio output is set to headset (“RJ

Conn” or “Chinch”), the snom220 will treat the headset as the output

device for calls. When the snom 220 is used in a call center environment

the connected headset will be the default setting for speaking on the

phone. The ENTER key

is therefore used to accept incoming calls.

Key mapping:

Switch to handsfree mode and back.

ENTER

Accept incoming calls in headset mode.

CANCEL

Returns the phone to the idle state.

Programmable Keys

The five keys to the right of the numbers block are the programmable

function keys that have the following options:

• Line

• Destination

• Intercom

• Park Orbit

• Voice Recorder

• DTMF (H323 only)

Each of these buttons has an LED indicating the status of the respective

programmable key at any given time.

Some features are common to all keys:

Pressing a key when its LED is blinking and the phone is ringing will

receive the call.

Pressing the key when a call is in progress at that key as indicated by

the constantly lighted LED, will put the call on hold.

Pressing a key while editing a number for dialing at that key will erase

the number and the phone will go to idle state.

Each of these different options will now be explained in detail.

Line

'Line' can be used in one of the following ways:

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 66 67

No comments

Snom 220 User Manual Page 22